|
 High
Performance Coatings offers a range of coatings specifically
engineered to your coating requirements. For applications
requiring a reduced coefficient of friction, as well as non-stick
and chemical resistance in various environments, these coatings
have the solutions to your needs.
SO1-K: Wettable Matrix Coating
This inorganic single-bonded dry film contains
a matrix selected to increase the lubricity and load-bearing
capability when subjected to high pressure and mid-range temperatures.
It provides excellent wear properties while reducing friction
loads. In applications where solutions such as petroleum products
are to be retained rather than shed, this process will increase
the life of the components by helping to eliminate fretting,
galling and seizure. Operating temperature: -73°C + 315°C.
Applications include:
- Machine slides
- Pistons in Bores - Hydraulic, Automotive
or compressor
- To protect heating elements
SO2-K: Non-Wettable Matrix Coating
Designed with PTFE, SO2 is a resin-bonded
dry film lubricant/non-stick coating. Dissimilar metal corrosion
between tightly compressed components will be greatly reduced
after being treated with SO2-K. Useful to reduce friction,
prevent scoring and galling or provide secondary lubrication
in the event of failure of the primary (conventional) lubricant.
SO2-K has excellent chemical resistance, a great operating
temperature range up to 315°C and the best low friction
characteristics available.
Applications include:
- Folding Plates for Plastic Film
- To stop Glues from sticking to Machinery
|
PO1
HPC's PO1 is a premium quality, high
temperature, chemical resistant coating with the additional
benefits of good electrical properties, good mechanical
properties with excellent release characteristic. PO1
is applied over a catalyed primer to achieve excellent
bond strength. The cured film has a service temperature
rating of 260°C.
Applications include:
- Trays for Heated Chemicals
- A release coating for Paint Vats
- To stop Molten Plastics from sticking
|
|
|
PO4
High Performance Coatings' PO4 is a
two coat system (one liquid, one powder) used primarily
for applications in the chemical processing industry.
Because it is a wet spray/powder bake on system, this
makes it an ideal candidate for odd shapes or structures
that 'plastic' or 'rubber' sheets cannot easily be shaped
to. Exhibiting good abrasion and chemical resistance
with some non-stick ability and a maximum working temperature
of 100°C. Can be applied to most metals and is recoatable.
Applications include:
- Mixer Blades
- Agitator Shaft Assemblies
- Spill Containment Frames
- Motor Housing
|
|
 LO1
Provides lubrication with extra corrosion
protection. It is used to coat large studs, nuts, bolts, flanges
and related hardware. Because of its predictable low friction
properties, less "makeup" torque is required to
achieve specified tension.
The frictional characteristics are the most predictable of
any lubricant, coating or plating used on bolting. The low
friction properties reduce 'breakout' torque which allows
bolts to be removed with a spanner and not a gas torch. Temperature
range 260°C continuous 315°C intermittent.
LO1 is also resistant to chemical attack. Matched with release
properties it can protect components and make them easier
to clean.
Applications include:
- Nuts, Bolts, Threads in corrosive environments
- Hot melt Glue tanks and application equipment
Return
to top of page
|
